HP iLO 3 User Guide

7. Click Apply.
Your changes are applied to the iLO network configuration, your browser connection ends,
and iLO restarts. You must wait at least 30 seconds before you attempt to re-establish a
connection.
Configuring iLO Management settings
The Administration→Management page allows you to configure the iLO settings for SNMP alerts
and Insight Manager integration.
You must have the Configure iLO Settings privilege to change these settings.
Depending on your configuration, you might need to install additional software. See “Installing
the Insight Management Agents” (page 84).
Installing the Insight Management Agents
The Insight Management Agents are available from the HP Service Pack for ProLiant and the HP
website. For instructions about using the HP Service Pack for ProLiant to install the Insight
Management Agents, see the Service Pack for ProLiant documentation.
To download the Insight Management Agents from the HP website:
1. Navigate to the technical support page on the HP website: http://www.hp.com/support.
2. Select a country or region and a language.
The HP Support page opens.
3. Click the Drivers & Downloads link.
In the search box, enter the server model that you are using (for example, DL360p).
A list of servers is displayed.
4. Click the link for your server.
The HP Support Center page for the server opens.
5. Click the link for the server operating system.
6. Download the software.
7. Follow the installation instructions provided with the downloaded software.
Configuring SNMP alerts
You can enable or disable iLO SNMP alerts, forwarding of Insight Management Agent SNMP
alerts, and SNMP Pass-thru.
To configure SNMP alerts:
1. Navigate to the Administration→Management page.
2. Click the SNMP Settings tab and scroll to the SNMP Alerts section, as shown in Figure 37).
Figure 37 Editing the SNMP alerts
84 Configuring iLO