Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Adding Additional Components
Adding Internal Components
Chapter 3
36
Adding Internal Components
Use these procedures to install any internal components that were not installed into your server blade. Before
you can install the internal components, you need to remove the access panel.
Removing the Access Panel
To remove the access panel, perform the following steps:
Step 1. Loosen the thumbscrew (1).
Step 2. Press down on the thumb indentations, slide the access panel toward the rear of the unit about
1.25 cm (0.5 in), and lift to remove the panel (2). See Figure 3-3.
Figure 3-3 Removing the Server Blade Access Panel
Once the access panel is off, you can do the following:
• Add an additional processor
If you are adding a processor to your server blade, go to “Adding a Processor” on page 36.
• Add additional memory DIMMs
If you are adding memory DIMMs to your server blade, go to “Adding Memory DIMMs” on page 43.
Adding a Processor
Use this procedure to install an additional processor into the server blade. Handle the processor and power
pod assembly carefully. The processor and power pod assembly used in the server blade is very delicate and
can be easily damaged.
If you are not adding a processor to the server blade, but are installing additional memory DIMMs, go to
“Adding Memory DIMMs” on page 43.
Front of
Server