Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Adding Additional Components

Adding Internal Components

Chapter 3

Figure 3-13 Installing Processor Module on Server Blade Board

Step 11. Connect the power cable to the pod power connector on the processor power pod module.

Step 12. Install the fan assembly by performing the following steps:

a. Place the fan assembly into the server blade, and push down on the assembly until the

retention tab clicks into place.

NOTE Make sure to route the processor module power wires through the gap on the fan

bracket.

b. Connect the four fan assembly cables to the system board. See Figure 3-6.

Step 13. Install the airflow guide by lowering the airflow guide on top of the processors, with the flanges

going between the fans on the fan assembly. Route the wires into the slots on the airflow guide. See

Figure 3-14 and Figure 3-15.

Front of server