Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Adding Additional Components
Adding Internal Components
Chapter 3
43
Figure 3-14 Airflow Guide
Figure 3-15 Replacing the Airflow Guide
NOTE If you are only adding a processor to your server blade, and not adding memory DIMMs, go to
“Replacing the Access Panel” on page 45. If you are adding DIMMs, go to “Adding Memory
DIMMs” on page 43.
Adding Memory DIMMs
Four DIMM slots are provided on the system board. These DIMM slots are designated in ordered pairs, 0A –
0B; and 1A – 1B (see to Figure 3-16 for DIMM slot locations). DIMM sizes within each pair must match.
Loading order for the DIMM slots is sequential with the loading order being 0A – 0B, and 1A – 1B.
The server blade uses a minimum of 1 GB of memory (two 512 MB DIMMs), and a maximum of 8 GB of
memory (four 2 GB DIMMs). If you have purchased additional memory, use these procedures to install more
memory into your blade server.
Airflow guide
Flanges
Airflow guide
Flanges