Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Adding Additional Components
Adding Internal Components
Chapter 3
45
Figure 3-17 Installing a DIMM
Replacing the Access Panel
To replace the access panel, perform the following steps:
Step 1. Place the access panel on the blade with the panel hanging over the back of the enclosure about
1.25 cm (0.5 in), and slide the access panel toward the front of the server until the thumb
indentations click into place (1).
Step 2. Tighten the thumbscrew (2). See Figure 3-18.
Figure 3-18 Replacing the Access Panel