User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Appendix C
Utilities
Management Processor Command Interface
149
Command Mode
CM: Command Mode—enter command mode
This command switches the console terminal from the MP Main Menu to mirrored command interface mode.
If the current mux authority is administrator and the new login is as operator, the command mux is
denied (remains in MP Main Menu mode). If a command is in progress, a message displays warning the new
user of system status.
Console
CO: COnsole—leave command mode and enter console mode
This command switches the console terminal from the MP Main Menu to mirrored/redirected console mode.
All mirrored data displays. Type
Ctrl+B to return to the MP Main Menu.
For VT100 and HPterm, verify that the MP setting in the CA command is correct and all mirrored consoles
are of the same terminal type for proper operation.
<Ctrl+B>
<Ctrl+B>: Return to MP Main Menu from any submenu in the MP environment.
This command returns you to the MP Main Menu from anywhere in the MP environment.
<Ctrl+N>rs
<Ctrl+N>rs: Reset MP and allow password reset
This command resets the MP if it is hung. Use this in the place of the MP reset button (not part of the BL60p
server blade). It also allows you to reset the MP password.
IMPORTANT You can only run this command when directly connected to the server blade.
NOTE To execute this command, press the Ctrl key and the N key. Release these keys, and press rs.
Date
DATE: Date display
This command displays the current date, as generated by the OS or system firmware.
Default Configuration
DC: Default Configuration—reset all MP parameters to the default configuration
This command sets all MP parameters back to their default values. You may reset all, or a subset of the
following parameters:
• IP configurations
• Command Interface configuration
• Disable remote access, security configuration