User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Console Setup and Connection
Configuring iLO MP Access
Appendix D
160
Figure D-2 Connecting a Terminal to the Server Blade
Step 3. Verify the parameters for RS-232 serial port communication are set to the following values on your
terminal or emulator device:
• VT 100 protocol
• 8/none (parity)
• 9600 baud
• None (receive)
• None (transmit)
Step 4. Click OK to set the parameters.
Step 5. If running an emulator, launch it now. You should be at the MP prompt. Proceed to “Accessing the
iLO MP” on page 162.
Configuring ARP Ping to Enable iLO MP Access
This procedure details how to configure ARP ping to enable iLO MP access. Use the ARP ping method to
configure an IP address. You can configure the IP address using the ARP ping method remotely.
To configure the iLO MP LAN static IP address using the ARP ping method, perform the following steps:
Step 1. Obtain the Media Access Control (MAC) address of the iLO MP LAN interface from the label
located on the top of the server. Refer to Figure D-3.