User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Removing and Replacing Components

Removing and Replacing the Server Blade Access Panel

Chapter 4

Removing and Replacing the Server Blade Access Panel

The access panel is located on the right side of the server blade (when mounted in an enclosure).

Removing the Server Blade Access Panel

To remove the access panel, perform the following steps:

Step 1. Power off the server blade and remove it from the server blade enclosure. Refer to “Preparing the

Server Blade for Servicing” on page 44.

Step 2. Loosen the thumbscrew (1).

Step 3. Press down on the thumb indentations, slide the access panel toward the rear of the unit about

1.25 cm (0.5 in), and lift to remove the panel (2). Refer to Figure 4-8.

Figure 4-8 Removing the Server Blade Access Panel

Replacing the Server Blade Access Panel

To replace the access panel, perform the following steps:

Step 1. Place the access panel on the blade with the panel hanging over the back of the enclosure about

1.25 cm (0.5 in), and slide the access panel toward the front of the server until the thumb

indentations click into place (1). Refer to Figure 4-9

Step 2. Tighten the thumbscrew (2).

Step 3. Place the server blade back into the enclosure and power it on. Refer to “Preparing the Server

Blade for Servicing” on page 44.