Manualshelf

Installation Guide, Second Edition - HP Integrity BL60p Server Blade

ManualsBrandsHP ManualsServerHP Integrity BL60p Pre-Configured Server
51525354555657585960
Chapter 5
51
5 Configuring iLO MP Access
On the initial install of the BL60p server blade into the enclosure, you need to access iLO MP. Before you can
access iLO MP, you must perform configuration steps to enable iLO MP access. An iLO MP connection is
required to allow initial access to EFI and the OS. You use iLO MP to provide advanced troubleshooting,
diagnostics, and the initial network configuration of the server blade. There are three ways to configure iLO
MP access. Use one of the following procedures listed below to configure your access to iLO MP.
This chapter addresses the following topics:
• “Configuring DHCP to Enable iLO MP Access” on page 52
• “Configuring the RS-232 Port to Enable iLO MP Access” on page 52
• “Configuring ARP Ping to Enable iLO MP Access” on page 55