Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Configuring iLO MP Access

Configuring ARP Ping to Enable iLO MP Access

Chapter 5

Configuring ARP Ping to Enable iLO MP Access

This procedure details how to configure ARP ping to enable iLO MP access. Use the ARP ping method to

configure an IP address. You can configure the IP address using the ARP ping method remotely.

To configure the iLO MP LAN static IP address using the ARP ping method, perform the following steps:

Step 1. Obtain the Media Access Control (MAC) address of the iLO MP LAN interface from the label

located on the top of the server. See Figure 5-3. You should already have MAC address written

down from an earlier step in the install process (see “Installing the Server Blade into the

Enclosure” on page 48).

Figure 5-3 MAC Address Location

Step 2. Connect a LAN cable on your local subnet to the core iLO MP LAN port on the rear of the server

blade enclosure (if not already connected). See Figure 5-4.

MAC address

label