Installation Guide, Second Edition - HP Integrity BL60p Server Blade

Chapter 10
Troubleshooting
Server Does Not Power On
79
Server Does Not Power On
If your server does not power up, check the LED indicators front panel. Perform the following:
• If no LEDs are lit on your server blade, there may not be enough power available from the server blade
enclosure.
On Flashing Off Do not remove the drive. Removing a drive during this
process causes data loss.
The drive is rebuilding or undergoing capacity expansion.
Flashing Flashing Flashing Do not remove the drive. Removing a drive during this
process causes data loss.
The drive is part of an array being selected by the Array
Configuration Utility.
-or-
The Options ROMPaq is upgrading the drive.
Off Off Off OK to replace the drive online if a predictive failure alert is
received and the drive is attached to an array controller.
The drive is not configured as part of an array.
-or-
If this drive is part of an array, a powered-on controller is not
accessing the drive.
-or-
The drive is configured as an online spare.
Off Off On OK to replace the drive online.
The drive has failed and has been placed offline.
Off On Off OK to replace the drive online if a predictive failure alert is
received, provided that the array is configured for fault
tolerance and all other drives in the array are online.
The drive is online and configured as part of an array.
On or
flashing
On Off OK to replace the drive online if a predictive failure alert is
received, provided that the array is configured for fault
tolerance and all other drives in the array are online.
The drive is online and being accessed.
Table 10-2 Hot-plug SCSI Hard Drive LEDs (Continued)
1 - Activity 2 - Online 3 - Fault 4 - Means