User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Appendix C
Utilities
Management Processor Command Interface
155
The SS command displays the status of the system processors and which processor is the monarch.
Firmware Revision Status
SYSREV: Displays the revision status of firmware in the system.
This command displays the revision status of firmware in the system.
NOTE At the time of production of this guide, the firmware revisions were:
FIRMWARE INFORMATION
MP FW: H.03.15
BMC FW: 04.05
EFI FW: 05.16
System FW: 62.14
Transfer Of Control
TC: System reset through INIT or TOC (Transfer of Control) signal
Under normal operation, shut down the OS before issuing this command.
This command causes the system to be reset through the INIT (or TOC) signal. Execution of this command
irrecoverably halts all system processing and I/O activity and restarts the computer system. It is different
from the RS command in that the processors are signaled to dump state on the way down.
Tell
TE: TEll—sends a message to other terminals
Up to 80 characters can be typed in. The message is broadcast to the other mirrored clients. The message
displays to all users currently in the MP Command Mode.
User Configuration
UC: User Configuration—controls user access
Use this command to modify the user configuration of the MP. These include user accounts, passwords, etc.
There are two default users - Admin and Oper. The Admin user has all 4 rights (C,P,M and U), and the Oper
user has the Console access right by default. The configuration of these default users can also be changed
using this command. Most of the parameters are familiar, the following require some extra explanation:
MODE: Single/Multiple If the mode is Single, the state changes to disabled after the first login
USER'S STATE: Enabled/Disabled A disabled user's login is not accepted
SYSREV or SR command (at time of release):
MP FW : H.03.19
BMC FW : 04.08
FI FW : 05.16
System FW : 01.60