User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Power Off and Power On the Server
Power On the Server
Chapter 3
35
Power On the Server
The following procedure describes how to power on your server blade.
Step 1. Install your server blade into the server blade enclosure. Refer to “Replacing the Server Blade into
the Enclosure” on page 46.
Depending on your server blade settings, installing the server blade may either go to standby
power mode, or go to full power and start the boot process.
Step 2. If the server blade is in standby mode, press the power button to get your server to full power.
Step 3. Start your operating system (if not already autobooting). Refer to Appendix B, “Operating System
Boot and Shutdown,” on page 103, or your operating system documentation for more information.