User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Removing and Replacing Components
Removing and Replacing the Fan Assembly
Chapter 4
53
Removing and Replacing the Fan Assembly
The fan assembly in the server blade includes four dual-bladed fans connected together in a plastic assembly.
Each fan has a power connector that attaches to the system board.
Removing the Fan Assembly
To remove the fan assembly, perform the following steps:
Step 1. Power off the server blade and remove it from the server blade enclosure. Refer to “Preparing the
Server Blade for Servicing” on page 44.
Step 2. Remove the access panel. Refer to “Removing the Server Blade Access Panel” on page 47.
Step 3. Remove the airflow guide. Refer to “Removing the Airflow Guide” on page 51.
Step 4. Disconnect the four fan assembly cables from the system board. Refer to Figure 4-14.
Figure 4-14 Power Connectors on Fan Assembly
Step 5. Press the fan retention tab and lift the assembly out of the server blade. Refer to Figure 4-15.
Front of server
Fan assembly
retaining clip
Fan power
connectors