User Service Guide, Second Edition - HP Integrity BL60p Server Blade

Removing and Replacing Components
Removing and Replacing DIMMs
Chapter 4
57
Replacing a DIMM
To replace a DIMM, perform the following steps:
Step 1. Ensure the DIMM slot latches are open.
CAUTION Use only HP low-profile (1.2 in.) DIMMs. DIMMs from other sources may adversely
affect data integrity.
Step 2. Insert DIMM in slot (1) and push down until the latches click shut (2). Refer to Figure 4-18.
Step 3. Replace the access panel. Refer to the “Replacing the Server Blade Access Panel” on page 47.
Step 4. Place the server blade into the enclosure and power it up. Refer to “Replacing the Server Blade into
the Enclosure” on page 46.
Figure 4-18 Replacing a DIMM