HP Integrity iLO 3 Operations Guide

Figure 33 Serial
Table 27 Serial description
DescriptionItem
Enables you to set the local serial mode of operation to either the iLO MP or Auxiliary
UART mode. Switching to AUX UART mode when MP LAN access is disabled requires
Mode of Operation
a push-button reset of the iLO 3 Physical Presence button to return to iLO 3 mode. If baud
rate settings are not consistent between the serial port and the attached serial device,
communication issues occur.
Enables you to set the iLO 3 baud rate. Input and output data rates are the same. The
iLO 3 default baud rate is 9600 bps, 8 bits, 1 stop, no parity.
iLO Bit Rate in Bits per
Second
Enables you to set the iLO 3 flow control. Flow control can be through hardware or
software. Hardware uses RTS/CTS. Software uses Xon or Xoff.
Flow Control
Submits the information.Submit
Cancels the action.Cancel
Relevant iLO MP TUI command: CA
Login Options
The Login Option tab enables you to modify the security options of iLO 3. To use this feature, you
must have the Configure iLO Settings user right.
Web GUI 105