HP Integrity iLO 3 Operations Guide

Figure 34 Login Options
Table 28 Login Options description
DescriptionItem
If a user remains at the MP login: prompt for longer than the timeout, iLO 3 disconnects
the user from SSH or Telnet. The default value is 1 minute; it can be configured to a value
Login Timeout in Minutes
in the range of 1 to 5 minutes. This timeout does not apply to users who have successfully
logged in to iLO 3. The timeout value in minutes is effective on all ports, including local
ports.
Sets a limit on the number of password faults allowed when logging in to iLO 3. The
default number of password faults allowed is three. If a greater number of faults is
Password Faults Allowed
detected, the user is disconnected. It can be configured to a value in the range of 1 to
10.
Can be used to disable Security Override mode at any time before the 15-minute override
timeout. Security Override mode can be disabled only when set by a Physical Presence
Security Override Mode
button push, not when the Security Override switch is set. You cannot use this field to
enable Security Override mode. The enable/disable buttons are gray unless security
override is in effect.
Submits the information.Submit
Cancels the action.Cancel
Relevant iLO MP TUI command: SO
Directory Settings>Current LDAP Parameters
The Current LDAP Parameters page enables you to edit the directory parameters. To use this feature,
you must have the Configure iLO Settings user right.
106 Using iLO 3