HP Integrity iLO 3 Operations Guide

Unless SSH is disabled and the local user database is disabled (enabled is default), you can
connect from the OA using connect server n.
On HP Integrity server blades, you also have access to the console port.
It is not necessary to physically connect to iLO 3 through the console serial port to perform
management tasks. Use the OA/iLO LAN port to communicate with any iLO 3 in the enclosure
and the OA. You can use the LCD panel and the OA to configure and determine the iLO MP LAN
address.
To log in to iLO 3, see Chapter 4 (page 32).
Additional setup
This section provides additional information to set up iLO 3.
Integrity iLO 3 comes preconfigured with an Administrator account and a randomly generated
password.
All Rights (Administrator) level user:
login = Administrator
password = Randomly generated password found on the iLO Network Information Tag
NOTE:
• On server blades, the iLO Network Information Tag is located on the right side of the monarch
blade.
• On HP Integrity rx2800 i2/i4 servers, the iLO 3 Network Information Tag is located on a
pull-tab on the front panel.
Modifying default account configuration settings
Log in as the Administrator.
Changing the default password
1. Access the MP Main Menu.
2. At the hpiLO-> prompt, enter CM.
3. At the CM:hpiLO-> prompt, enter UC and follow the prompts.
Setting up user accounts
1. Access the MP Main Menu.
2. At the hpiLO-> prompt, enter CM.
3. At the CM:hpiLO-> prompt, enter UC and follow the prompts to modify user accounts.
Setting up security
For greater security, HP recommends that only administrators be granted access to modify user
account information.
30 Getting connected to iLO 3