HP Integrity iLO 3 Operations Guide

LS: LAN status
Command access level: Login access
The LS command .
Command line usage and scripting:
LS [ -nc ]
LS -?
PC: Power control
Command access level: Power control access
The PC command is used to obtain an instantaneous power reading and control system power. It
provides the following options for remote control of system power:
ON Turns the system power on. This command has no affect if the power
is already on.
OFF Turns the system power off. This command is equivalent to turning the
system power off at the front panel switch. There is no signal sent to
the operating system to shut the software down before power is turned
off. To turn the system off gracefully, ensure that the operating system
is shut down before running this command.
CYCLE Turns the system power off, then on. The delay between off and on is
6 seconds.
Graceful Shutdown A signal is sent to the operating system to shut down prior to turning
off the system power.
Command line usage and scripting:
PC [ -on | -off | -graceful | -cycle ] [ -nc ]
PC -?
Example:
[gstlhpg1] CM:hpiLO-> pc -on -nc
PC -on -nc
System will be powered on.
-> System is being powered on.
-> Command successful.
[gstlhpg1] CM:hpiLO->
See also: PR, PS
PM: Power regulator mode
Command access level: Power control access
The PM command provides the following options for remote control of the system power regulator:
Dynamic Enables the system to dynamically change the processor power level when needed
based on current operating conditions. The system remains in this mode unless the
system is reset or an operating system-hosted application requests a processor state
change. In these cases, power management mode changes to operating system Control
Mode.
Low Sets the processor to the lowest supported processor state and forces it to stay in that
lowest state until the system is reset. If the processor is reset, the power mode changes
to operating system Control Mode.
Text user interface 61