HP Integrity iLO 3 Operations Guide
Table 22 Power Regulator & Capping description (continued)
DescriptionItem
OS Control Mode This mode configures the server to enable the
operating system to control the processor p-states.
Use this setting to put the Operating System
(including OS-hosted applications) in charge of
power management.
Power Capping Settings Power Cap Value The power cap value in watts or Btu/hr and
percentage.
Maximum Power Rating Maximum power cap allowed.
Peak Observed Power A power cap at or above this value should have no
impact on server performance.
Minimum Observed Power Idle power consumption and lowest possible power
cap. A power cap near minimum power might have
significant impact on server performance.
Select how you want the values to display.Show values in Btu/hr or
Show values in watts
NOTE: Power caps set to less than 50% of the difference between peak observed power and
minimum observed power might become unreachable due to changes in the server. Power caps
set to less than 20% are not recommended, and might cause the server to reboot or the server OS
to stop responding.
Relevant iLO MP TUI command: PM
Administration
The Administration menu enables you to access the following pages:
• Firmware Upgrade
• Licensing
• Local Accounts
• Group Accounts
• Access Settings
• Directory Settings
• Network Settings
• BladeSystem Onboard Administrator (OA) (Available only for server blade)
Firmware Upgrade
The Firmware Upgrade page enables you to upgrade the iLO 3 and system programmable firmware.
To use this feature, you must have the Configure iLO Settings user right.
Web GUI 95