HP Integrity iLO 3 Operations Guide

If a firmware request is pending when you enter the FW command, a SYSREV table appears. You
will be prompted to either cancel the firmware upgrade request or exit. Follow the prompts on the
screen.
The FW command upgrades iLO MP or specific system programmable firmware.
• If only upgrading the iLO MP firmware, the iLO MP automatically resets upon successful
completion dropping all iLO MP LAN connections. This upgrade will not affect server operation
if it is for iLO MP only.
• If this upgrade is system programmable firmware, the upgrade can be completed without
resetting iLO, however, the server needs to be reset for the pending system programmable
firmware revisions to become active. Resetting the server to activate pending firmware can
take up to 10 minutes before the server begins to boot.
After the upgrade, reconnect and log in.
TIP: Before performing certain iLO 3 functions, verify that you have the supported firmware
version required to carry out the task.
Licensing
The Licensing page displays the factory-installed iLO 3 Advanced Pack License Key.
The iLO 3 firmware comes with a full-featured permanent default Advanced Pack Licensing Key
built in. No additional licensing is necessary. The New Permanent Licensing Key field is reserved
for future use. This field is unused in Integrity iLO 3 v1.00.
IMPORTANT: The HP ProLiant iLO 3 Advanced Pack Licensing Key will not work on an HP Integrity
server blade and vice versa.
Figure 29 Licensing
Web GUI 97