Manualshelf

HP Integrity cx2600 Operations and Maintenance Guide

ManualsBrandsHP ManualsServerHP Integrity cx2600 Server
61626364656667686970
Figure 4-2 Rear Panel LEDs
8
Power Supply Fault LED
5
Power Supply Fault LED
1
MP LAN LEDs
2
Gigabit LAN LEDs
9
Power Supply DC Out
LED
6
Power Supply DC Out
LED
3
System Management
LAN (10/100) LEDs
107
Power Supply DC In LEDPower Supply DC In LED
4
Locator Button LEDs
Table 4-4 Rear Panel LED Definitions
DescriptionColorLED/Button
When off, self test is not active. When lit, the MP is running self test.GreenMP Self Test LED (top)
When off, no link detected or 100 BT link is active. When flashing,
indicates 10 BT LAN activity. When lit steady, indicates that 10 BT link
has been established.
GreenMP 10BT LED (2nd from top)
When off, no link detected or 10 BT link is active. When flashing,
indicates 100 BT LAN activity. When lit steady, indicates that 100 BT
link has been established.
GreenMP 100BT LED (2nd from bottom)
When off, standby power is not applied to MP LAN circuits. When lit,
power is connected to the server but the server is not on.
GreenMP LAN Standby Power LED
(bottom)
When off, no 1000 Mbps link has been detected. When lit, port is linked
at 1000 Mb/s.
GreenGigabit LAN Gbit LED (top)
When off, no 100 Mbps link has been detected. When lit, port is linked
at 100 Mb/s.
GreenGigabit LAN 100 Mbit LED (2nd
from top)
When off, no 10 Mbps link has been detected. When lit, port is linked
at 10 Mb/s.
GreenGigabit LAN Link LED (2nd from
bottom)
When off, no LAN activity has been detected. When lit, port is linked
at 1000 Mb/s.
GreenGigabit LAN Activity LED
(bottom)
When lit, shows that port is linked.GreenSystem Management LAN
Activity LED
When off and Activity LED is lit, shows that port is linked to 10 Mb
LAN. When lit, shows that port is linked to 100 Mb LAN.
GreenSystem Management LAN Speed
LED
Lit by pressing the associated button, by pressing the corresponding
button on the front panel, or by command from a remote location.
BlueLocator
Identifies one server among many. Also tests for a running BMC on
the system board.
Troubleshooting Using LED Indicators 61