HP Server Slide Mount Kit AB294A for NEBS 2000 Rack Installation Instructions Manufacturing Part Number: AB294-96001 April 2004 U.S.A. © Copyright 2004 Hewlett-Packard Development Company, L.P..
Legal Notices Copyright Notices. © Copyright 2004 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Printed in the U.S.A.
1 HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions Introduction This manual provides instructions for installation of the hp Integrity cx2600 server chassis on slides in a NEBS 2000 rack. Cabinet Safety Precautions WARNING Ensure that the rack is level and stable before working on the rack. Be sure the leveling jacks (feet) extend to the floor and that the full weight of the rack rests firmly on the floor. WARNING Ensure that the rack has anti-tip measures in place.
HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions Introduction Mounting Kit Contents This manual provides installation instructions for server mount kit AB294A.
HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions Installation Procedure Installation Procedure Figure 1-1 HP Integrity cx2600 Servers Mounted in a NEBS 2000 Rack 2600inrack1 Mounting Kit Before mounting your server in the NEBS 2000 rack, inspect the mounting kit hardware. Check that all required mounting hardware is available. A mounting kit parts list is provided at the rear of this manual. Mount the Server Mount a server in the NEBS 2000 rack as follows: Step 1.
HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions Installation Procedure Figure 1-2Attach the Cable Routing Brackets and Inner Slides to the Server Cable Routing Brackets T15 Waferscrews Inner Slide Rail Inner Slide Rail chasrails1 Step 3. Remove the inner rail assemblies (inside track slides) from the slide assemblies and attach an inner rail to each side of the server chassis with T15 waferscrews. (Observe that the bend in this slide rail is at the front of the chassis.
HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions Installation Procedure Step 6. Tighten the rear screws (loosened in step 4) on the outer slide rails. Step 7. Install the rack mount retainer bars on the inner side of each column, above the slides as shown in Figure 1-3. Secure each retainer bar with one T25 screw, using the top threaded hole in the retainer bar. Step 8.
HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions AB294A Rack Mount Kit AB294A Rack Mount Kit The HP Server Mounting Kit, part number AB294A includes the items listed below.
