Installation Instructions - HP Server Slide Mount Kit AB294A for NEBS 2000 Rack

HP Server Slide Mount Kit for NEBS 2000 Rack – Installation Instructions
Installation Procedure
Chapter 1
6
Figure 1-2Attach the Cable Routing Brackets and Inner Slides to the Server
Step 3. Remove the inner rail assemblies (inside track slides) from the slide assemblies and attach an inner
rail to each side of the server chassis with T15 waferscrews. (Observe that the bend in this slide rail
is at the front of the chassis.)
Step 4. Remove the outer rail assemblies from the slide assemblies and loosen the rear screws.
Step 5. Install the outer rails in the rack at the desired mounting position. Push slide rails tightly against
the rack columns while securing the rails in place with T25 screws.
Figure 1-3Attach the Outer Slide Assemblies to the Rack Columns
chasrails1
Cable
Routing
Brackets
Inner Slide Rail
Inner Slide Rail
T15
Waferscrews
rckrails2
T25 Screws
Rack Mount
Bracket
Retainer Bar
T25 Screws
Outer Slide
Rails