Installation Instructions - HP Server Slide Mount Kit AB296A for HP 10000 Rack

HP Server Slide Mount Kit for HP 10000 Rack – Installation Instructions
Installation Procedure
Chapter 1
6
Figure 1-2 Slide Assemblies
Step 2. Attach a HP 10000 rack ear slide to each side of the server chassis with T15 flathead screws.
Figure 1-3Attach the Inner Slide Assemblies to Server Chassis
Step 3. Remove the inside rail assemblies from the slide assemblies, and attach an inside slide to each side
of the server chassis with T15 waferscrews. (Observe that the bend in this slide rail is at the front of
the chassis.)
Step 4. Remove the outer rail assemblies from the slide assemblies and loosen the rear screws.
Step 5. Install the outer rails in the rack at the desired mounting position. Hold rails tightly against the
rack columns while securing the rails in place with T25 screws (with crestcup washers).
slides
Rear
Mount
Bracket
Outer
Slide
Slide
Bracket
Inner
Slide
Front
Mount
Bracket
chasrails2
T15
Flathead
Screws
Rack
Ear
Slide
T15
Waferscrews
Inner SlideInner Slide