Installation Instructions - HP Server Slide Mount Kit AB296A for HP 10000 Rack

HP Server Slide Mount Kit for HP 10000 Rack – Installation Instructions

Installation Procedure

Chapter 1

Step 8. Insert the chassis-mounted slides (inside rail assembly) into the rack-mounted slides (outer rail

assembly) and push the chassis fully into the rack. Press the blue tabs on the slides to release slide

locks and allow insertion.

Step 9. Secure the chassis to the front of the rack with T25 screws. (The screws thread into the cage nuts

installed in step 7.)

Step 10. Loosely install the rear rack brackets above the slides on the rear rack columns with T25 screws

and cage nuts. (See Figure 1-6.)

Figure 1-6Install the Cable Management Bar

Step 11. Secure the cable management bar to the rear rack brackets by tightening the thumbscrews of the

cable management bar.

Step 12. Tighten the T25 screws that hold the rear rack brackets (installed in step 10) in place.

cmbar3

Rear Rack Bracket

and 2 Cafe Nuts

T25 Screws