Installation Instructions - HP Server Static Mount Kit AB295A for HP 10000 Rack

HP Server Static Mount Kit for HP 10000 Rack – Installation Instructions
Installation Procedure
Chapter 1
5
Figure 1-2Attach the Brackets and Rack Ears to the Server Chassis
Step 2. Attach the rear rack ears to the server chassis using T15 flathead screws.
Step 3. Install left and right HP 10000 rack rails at desired position in rack as shown in Figure 1-3. Insert
M5 cagenuts into the rack columns and secure rails to the rack columns using T25 M5 screws.
Tighten the front screws before tightening the rear screws.
Figure 1-3Attach the Rails to the Rack Columns
Step 4. Install four M5 cagenuts in front rack columns, above the rails. Then slide the server into position
on the rails and secure it to the front columns with T25 M5 screws threaded into the cagenuts, as
shown in Figure 1-4.
chasbrkt2
Rear Cable
Routing Bracket
T15 Flathead
Screws
Rear Rack Ear
rckrail3
T25 M5 Screws