Installation Guide, Second Edition - HP Integrity cx2620

Figure 1-8 Installing the Front Grill
chasfrntoff
Captive Screws
Removing the Front Grill
NOTE: If you have an air filter assembly installed, remove the air filter assembly before removing
the front grill. To remove the air filter assembly, see the HP Integrity cx2620 User Service Guide.
To remove the front grill, follow these steps:
1. Use the ACX-15 Torx screwdriver to loosen the five captive screws that secure the grill to
the chassis.
2. Pull the grill from the front of the server chassis.
Installing the Top Cover
To install the top cover, follow these steps:
1. Align each pair of tabs on the left and right sides of the cover with the corresponding slots
in the chassis. Set the cover in place on the chassis.
2. Align the three tabs on the front of the cover with the corresponding apertures at the top
front of the chassis and insert the tabs into the slots.
3. Push the cover forward until it seats on the chassis.
4. Tighten the captive screw to secure the cover in place.
Removing the Top Cover
To remove the top cover, follow these steps:
26 Installing the System