Installation Guide, Second Edition - HP Integrity cx2620

3. If desired, remove the server from the rack and place it on an ESD protected work surface.
See “Removing the Server from a Rack” (page 21).
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware unless you are removing
or installing a hot-swappable or hot-pluggable component.
Voltages are present at various locations within the server whenever a dc power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
4. Remove the top cover from the chassis. See “Removing the Top Cover” (page 26).
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure
to follow ESD safety precautions can result in damage to the server.
5. Pull up on the PCI-X card cage release lever and the back edge of the card cage, and lift the
card cage out of the server chassis (Figure 1-11).
Figure 1-11 Removing the PCI-X Card Cage
chaspciccdwn
PCI Card
Cage
Release
Lever
6. Place the card cage on an ESD-protected work surface so the PCI-X card connectors (within
the card cage) are at the bottom.
7. To remove a card, lift the card from its socket.
8. Remove the cover that is now on top of the card cage by sliding the cover toward the rear
of the card cage and lifting the cover. Remove the cover from the card cage.
30 Installing the System