Installation Guide, Second Edition - HP Integrity cx2620

NOTE: The four connectors within the card cage are identical and have the same capabilities.
You can install a compatible PCI-X card in any slot.
Installing a PCI-X Card
NOTE: You must remove the PCI-X card cage from the server chassis to enable installation of
PCI-X cards.
The four connectors in the PCI-X card cage are identical and have the same capabilities. You can
install a compatible PCI-X card in any slot. You can remove cards by lifting them from the sockets.
To install a PCI-X card, follow these steps:
1. Remove the PCI-X card cage from the server chassis. See “Removing the PCI-X Card Cage
Assembly” (page 29).
2. Remove the cover from the PCI-X card cage.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure
to follow ESD safety precautions can result in damage to the server.
3. If there is a blank panel installed at the end of the card cage, remove the blank panel.
4. Grasp the card by opposite edges and orient the card so that its connector is aligned with
the card cage socket, and the PCI-X interface connector is extended through the opening at
the end of the card cage. Insert the card into the desired socket.
5. Secure the card in the card cage using the retaining screw provided.
6. Connect any cables (if appropriate) to the card.
Installing the PCI-X Card Cage Assembly
To install the PCI-X card cage assembly, follow these steps:
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
1. If the card cage cover is removed, insert the cover tabs at the fan end of the cover into the
corresponding slots on the card cage, and press the cover into position on the card cage.
Slide the cover toward the front of the card cage to secure the cover in place.
2. Orient the PCI-X card cage as shown in Figure 1-12. Lift the release lever and hold it in the
open position. Lower the card cage into position and press gently to seat the card cage
connectors.
Installing Additional Components 31