User Service Guide, Third Edition - HP Integrity cx2620 Server

6. Remove the board by lifting it off of the deck assembly.
Figure 6-20 Removing the LED Status Panel
chasdvdxtnd
LED Board
Mounting Screws
CD/DVD
LED Board
Installing the LED Status Panel
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
To install an LED status panel, follow these steps:
1. Engage the board lock apertures on the keyed standoffs on the deck, and slide the board
toward the rear to lock it. Install the two screws securing the board to the threaded standoffs.
2. Connect the cable to the small connector of the LED status panel.
3. Position the CD/DVD deck and LED status panel assembly into the front of the chassis and
fasten the two screws that secure it to the chassis (Figure 6-19).
182 Removing and Replacing Components