User Service Guide, Third Edition - HP Integrity cx2620 Server

Figure 6-45 Connect the Turbo Fan Cable
Front of Chassis
18. Connect the power module cable to the connector on the system board.
Figure 6-46 Connect the Power Module Cable
Front of Chassis
19. Place the processor airflow guide in position. See “Installing the Processor Airflow Guide”
(page 176).
20. Install the chassis top cover. See “Removing and Replacing the Top Cover” (page 158).
21. If necessary, reinstall the chassis in the rack. See “Inserting the Server Into a Rack” (page 156).
22. Reconnect power and system cables to rear panel connectors.
23. Turn on the system.
24. Run the info cpu command at the EFI Shell prompt to verify that the processor has been
installed correctly.
Removing and Replacing a Dual-Core System Processor
This section provides information about removing and replacing dual-core processors (CPUs)
on the system board. The server can include one or two dual-core processors. The dual-core
processors are located on the system board and are accessible after removing the top cover and
Removing and Replacing a Dual-Core System Processor 205