User Service Guide, Third Edition - HP Integrity cx2620 Server

Figure 1-12 System Board LEDs
Table 1-11 lists the system board LEDs.
Table 1-11 System Board LEDs
DescriptionLED
The standby LED displays the power status of the server. It is lit when power is applied (DC In
LED on either power supply is lit). If power is applied and this indicator is off, you may have to
replace the system board.
Standby
The baseboard management controller (BMC) heartbeat LED flashes whenever the BMC is active.
If this indicator is not blinking when the server is powered on (STBY LED is lit), you may have to
replace the system board.
BMC
The firmware LED lights when the boot process begins. If the server will not boot, and this LED
is off, you may have to replace the system board.
Firmware
External and Cable Connectors
This section provides information on the ports and connectors on the rear panel of the server.
Ports and Connectors
Figure 1-13 displays the ports and connectors on the rear panel of the server.
External and Cable Connectors 37