User Service Guide, Third Edition - HP Integrity cx2620 Server

in place. Do not extend tray-mounted servers. Tray-mounted servers are not locked in place
and can fall if extended from a rack.
6. Disengage the slides or mounting hardware and take the server to a static-free work station.
Install the Server into a Rack
WARNING! Do not attempt to lift the server alone. The server can weigh as much as 22.7
kilograms (50 lbs.). Serious injury can result if this warning is not observed.
To insert the server into the rack, follow these steps:
1. Engage the server slides or mounting kit, as appropriate.
2. Slide the server inward and push the server into the rack until it is in position.
3. Connect server cables to rear panel connectors.
4. Connect the rack or facility ground cable to chassis ground lug.
5. Replace or tighten the screws that fasten the server to the rack.
Installing Hot-Pluggable Disk Drives
The supported configuration of a server includes one, two, or three Low-Voltage-Differential
(LVD), hot-pluggable disk drives. If any of the three disk drives are not installed, you must install
a disk filler in the disk location.
Hot-pluggable disk drives are located at the front of the server (Figure 3-5). The following sections
describe how to install a hot-pluggable disk drive.
Figure 3-5 Hot-pluggable Disk Drive Slots
CAUTION: A hot-pluggable device can require interaction with the operating system before
you can safely remove or install the device into the server. Determine if the operating system
supports replacement of disk drives while the operating system is running. If the operating
system does not support this feature, shut down the operating system before performing these
procedures. Failure to observe this caution can result in system failure.
The following sections describe how to install a hot-pluggable disk drive.
Installing Hot-Pluggable Disk Drives
Up to three hot-plug disk drives can be installed in the server. Always use low profile disk drives
(1.0" height) in the server.
To install a hot-pluggable disk drive, follow these steps:
60 Installing the System