User Service Guide, Third Edition - HP Integrity cx2620 Server

2. Tighten the five captive screws to secure the grill to the server chassis (Figure 3-8).
Figure 3-8 Installing the Front Grill
Removing the Front Grill
NOTE: If you have an air filter assembly installed, remove the air filter assembly before removing
the front grill. To remove the air filter assembly, see “Removing and Replacing the Air Filter
Assembly” (page 172).
To remove the front grill, follow these steps:
1. Use the ACX-15 Torx screwdriver to loosen the five captive screws that secure the grill to
the chassis.
2. Pull the grill from the front of the server chassis.
Installing the Top Cover
To install the top cover, follow these steps:
1. Align each pair of tabs on the left and right sides of the cover with the corresponding slots
in the chassis. Set the cover in place on the chassis.
2. Align the three tabs on the front of the cover with the corresponding apertures at the top
front of the chassis and insert the tabs into the slots.
3. Push the cover forward until it seats on the chassis.
4. Tighten the captive screw to secure the cover in place.
Removing the Top Cover
To remove the top cover, follow these steps:
64 Installing the System