User Service Guide, Third Edition - HP Integrity cx2620 Server
1. Select the web interface functions by clicking the Function tabs at the top of the page. Each
function lists options in the Navigation Bar on the left side of the page.
2. Click an option link to display data in the Display screen; and click Refresh to update the
display.
3. Click the Remote Console tab. The remote console provides a serial console that behaves
similarly to the TUI.
Help
The iLO MP web interface has a robust help system. To launch iLO MP help, click the Help tab
in the Display screen or click the ? at the top right corner of each page to display help about that
page.
Accessing the Graphic Console Using VGA
VGA is a method you can use to access the graphic console.
NOTE: You cannot access the iLO MP using VGA.
This method requires three elements:
• Monitor (VGA connector)
• Keyboard (USB connector)
• Mouse (USB connector)
The graphic console output displays on the monitor screen.
IMPORTANT: The server console output does not display on the console device screen until
the server boots to the EFI Shell. Start a console session using the RS-232 serial console port
method to view console output prior to booting to the EFI Shell or to access the iLO MP. See
“Configuring the iLO MP LAN Using the RS-232 Serial Console Port” (page 91).
To access the graphic console with VGA, follow these steps:
1. Perform preparation tasks.
2. Connect the cables.
a. Connect the monitor VGA cable to the appropriate VGA port on your server.
b. Connect the keyboard USB cable to the appropriate USB port on your server.
c. Connect the mouse USB cable to the appropriate USB port on your server.
3. Power on the server. The EFI Shell prompt displays.
Powering OFF and Powering On the Server
This section provides information and procedures for powering off and powering on the server.
Powering On the Server
Power on the server to full power using the following methods if the server is in the standby
power state:
• iLO MP, using the PC command
• Manually, using the Power button
Powering On the Server Using the iLO MP
NOTE: If the power restore feature is set to Always On through the iLO MP PR command, the
server may automatically power on to the full power state.
To power on the server through the iLO MP, follow these steps:
96 Installing the System