User Service Guide, Third Edition - HP Integrity cx2620 Server

1. Plug all power cables into the receptacles on the rear panel of the server.
2. Start a console session, and access the iLO MP Main Menu.
3. To enable command mode, enter CM.
4. To use the remote power control command, enter PC.
5. To power on the server, enter ON, and enter YES when prompted to confirm the action.
6. Start the operating system. (For information, see the operating system documentation.)
Powering On the Server Manually
NOTE: If the power restore feature is set to Always On through the iLO MP PR command, the
server may automatically power on to the full power state.
To manually power on the server, follow these steps:
1. Plug all power cables into the receptacles on the rear panel of the server.
2. To start the server, press the Power button.
3. Start the operating system. (For information, see the operating system documentation.)
Powering Off the Server
Power off the server using the following methods if the server is in either the standby or full
power state:
• iLO MP, using the PC command
• Manually, using the Power button
Powering Off the Server Using the iLO MP
To power off the server through the iLO MP, follow these steps:
1. Gracefully shut down the operating system. For information, see the operating system
documentation.
2. Start a console session, and access the iLO MP Main Menu.
3. To enable command mode, enter CM.
4. To use the remote power control command, enter PC.
5. To power off the server, enter OFF, and enter YES when prompted to confirm the action.
IMPORTANT: All the DC voltage except for the standby power is now turned off from the
server. Therefore, DC voltage for standby power is still present in the server.
6. Unplug all power cables from the receptacles on the rear panel of the server.
Powering Off the Server Manually
To manually power off the server through the iLO MP, follow these steps:
1. Gracefully shut down the operating system. For information, see the operating system
documentation.
2. To power off the server, press the Power button.
IMPORTANT: The main DC voltage is now removed from the system; however, AC voltage
for standby power is still present in the server.
3. Unplug all power cables from the receptacles on the rear panel of the server.
Powering OFF and Powering On the Server 97