Asynchronous Terminals and Printer Processes Programming Manual

CONTROL, SETMODE, AND SETPARAM FOR TERMINALS
SETMODE Operations
10 = set parity checking by system (default is configured).
parameter-1 . 15 = 0 no checking
1 checking
parameter-2 is not used.
11 = set break ownership.
parameter-1 = 0 break disabled (default)
= cpu,pin break enabled
Terminal access type after break is pressed:
parameter-2 = 0 normal (any type access is permitted)
= 1 break (only break-type access is permitted)
12 = set terminal access type.
parameter-1 . 15 = 0 normal (any type access is permitted)
1 break (only break-type access is
permitted)
File access type:
parameter-2 . 15 = 0 normal (any type file access is
permitted)
1 break (only break-type file access is
permitted)
13 = set system read termination on ETX character (default is
configured).
parameter-1 = 0 no termination on ETX
= 1 termination on first character after ETX
= 3 termination on second character after ETX
parameter-2 is not used.
14 = set system read termination on interrupt characters
(default is configured).
parameter-1 . 15 = 0 no termination on interrupt characters
(transparent mode)
1 termination on any interrupt character
November 1987 B-3