AutoSYNC Software User's Guide (Update 17)

Operations and Management
HP AutoSYNC User’s Guide—522580-018
A-16
Migrating the Configuration Database
3. When primary processing has been switched back to \P and \B becomes the
destination system again, re-allow \B to accept synchronizations from \P on \B:.
Migrating the Configuration Database
The AutoSYNC configuration files and tables are described above in paragraph
AutoSYNC Configuration Database. The information stored in database tables
references local file names, system names and system numbers. As a consequence,
the replication of the configuration database to another system cannot be automated.
This section describes how to migrate the AutoSYNC configuration database to a new
system.
Migrating an AutoSYNC Source System
On the Existing Source System
1. Capture MapDB and Monitor information to use as reference when setting up the
new environment:
2. Capture the global parameter configuration:
3. Capture the syncuser configuration:
4. For each configured syncuser, capture configured syncfilesets:.
On the New Source System
1. Install AutoSYNC as described in Installing AutoSYNC on page 2-1.
When creating the new MapDB, use the INFO MAPDB output collected in infom as
a reference.
2. Authorize Autosync, using the STATUS MONITOR output collected in infom as a
reference.
CLEAR AUTOSYNC FROM \P;
OUT infom;INFO MAPDB,DETAIL;STATUS MONITOR *;
OUT infog;INFO GLOBALS,OBEYFORM;INFO LOCALS,OBEYFORM;
OUT infou;INFO SYNCUSER,OBEYFORM;
OUT inggguux;INFO BATCHID *,USER ggg,uux,OBEYFORM;
OUT inggguuy;INFO BATCHID *,USER ggg,uuy,OBEYFORM;
...
OUT inggguuz;INFO BATCHID *,USER ggg,uuz,OBEYFORM;