AutoSYNC Software User's Guide (Update 19)

Operations and Management
HP AutoSYNC User’s Guide—522580-020
A-18
Migrating an AutoSYNC Source System
3. If synchronizations are performed over TCP/IP, configure the TCP/IP connection as
described in Synchronization Over TCP/IP on page 7-1 and as instructed by the
network administrator.
4. At this point, issue the STATUS MONITOR command to verify the new
environment is correctly configured.
5. Configure the AutoSYNC GLOBAL and LOCAL parameters, using infog as the
command file.
6. Configure the syncusers:

Validate the information collected in infou for accuracy and completeness.

If a private copy of BACKUP is referenced in ADD SYNDCUSER, verify that it
exists on the new system. Update the location of the private copy of BACKUP
in the infou command file, if it is not in the same location on the new system.

Use infou as an obey file.
7. For each syncuser configured in the previous step:

Update the syncfileset inggguuu file to reflect the new source file names and
other adjustments. Other possible updates include:

If a private copy of BACKUP is referenced in ADD SYNCFILESET, verify
that it exists on the new system. Update the location of the private copy of
BACKUP in the infou command file, if it is not in the same location on the
new system.

If exclude files are referenced in ADD SYNCFILESET, verify that they exist
on the new system. Update their entries to reflect the new names of
excluded files.

If mapnames files are referenced in ADD SYNCFILESET, verify that they
exist on destination system and update their entries to reflect the new
mappings between source and destination.

Validate the information collected in inggguu for accuracy and
completeness.

Log on as the syncuser and use the corresponding inggguuu file as a
command file to configure the syncfilesets for this syncuser.
8. Test the new installation:

Validate the new configuration using the INFO GLOBAL, INFO SYNCUSER
and INFO SYNCFILESET commands.

Proceed with your usual testing suites, using one time syncs, the REPORT
command and activating syncfilesets progressively.