AutoSYNC Software User's Guide (Update 19)

One-time Synchronization
HP AutoSYNC User’s Guide—522580-020
3-10
Partitioned Files and Tables
command. AutoSYNC does not see the mapnames-file entry and assumes the
destination file is on $DATA01, and the following command will yield incorrect results:
Instead, first specify:
Then specify the volume mapping for the remaining secondary partitions in the
mapnames-file.
Changing Subvolume and File Name Mapping
Non-partitioned file
To synchronize the single partition file $DATA01.DB.FILE to subvolume and file
BACKDB.BACKFILE, use the following command:
Partitioned file
To synchronize the partitioned file $DATA*.DB.PARTFILE to different subvolume and
file names $DATA*.BACKDB.BACKFILE, the command must specify the primary
partition mapping,
and the mapnames file must contain an entry for each secondary partition, as follows:
File and Catalog Name Mapping using MAPNAMES
The MAPNAMES mapnames-file option mentioned throughout the preceding
paragraphs is used to specify the mapping of a source file set to a destination file set
and for catalog name mapping.
The mapnames-file is an edit or entry-sequenced file, located on the destination
system.
SYNC $DATA01.DB.PARTFILE TO \DEST.*.*.*, MAPNAMES mapnames-file;...
where mapnames-file has entry:
$DATA01.*.* TO $BACK01.*.*
SYNC $DATA01.DB.PARTFILE TO \DEST.$BACK01.*.*, MAPNAMES mapnames-file...;
SYNC $DATA01.DB.FILE TO $DATA01.BACKDB.BACKFILE,...;
SYNC $DATA01.DB.PARTFILE TO $DATA01.BACKDB.BACKFILE, MAPNAMES mapnames...;
$DATA02.DB.PARTFILE TO $DATA02.BACKDP.BACKFILE
$DATA03.DB.PARTFILE TO $DATA03.BACKDP.BACKFILE
...so on...