BackPak H4.00 Catalog Sync Option

Initial setup
20 BackPak H4.00 Catalog Sync Option
Configure the primary Data store
When the Catalog Sync option is set in the license key, the list of data stores shows a link to
“Catalog Sync Export” that is a third data store configuration page, in addition to the main
page and the “Advanced Properties” page.
Figure 5. Data store configuration - Menu page
In the main data store attributes, click the Switch to Edit mode link, click the Catalog Sync
Export link for a PRIMARY Data Store.
Catalog Sync Export configuration page
Figure 6. Data store configuration - Catalog export page
Page elements
Full export frequency: this is an alternative to the scheduling of a Full export
through NetBatch that is recommended. Full export frequency should only be
considered in special systems when NetBatch is not installed.
This parameter is tested when executing an export update: if the delay is reached the
export update will be converted into a full export.
The inconvenient of this scheduling is the full export will typically occur when
automatic incremental exports are initiated at the end of the regular backups; when
the system can be busy. Another inconvenient of replacing a small job by a large job
is the additional delay before the new metadata corresponding to the new backups is
saved to the remote staging area.
Export check delay: this enables the retry of export by the EMS Extractor, when
export updates are not yet sent to the staging area.