BackPak H4.00 Troubleshooting and Messages Manual

Messages
37 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3015 VT Controller %1 in
drive %2 definition is
unknown
Referential integrity
error in the Domain
configuration.
Contact the Product
Support.
3016 MountId: %1.%2.
Volume %3 %4 is not
defined for automatic
load
Automatic load is
rejected because the
volume was created with
the attribute “No
automatic load”.
Issue a manual mount.
3018 DataStore %1 recorded
for volume %2-%3 is
unknown
The DataStore where a
volume was stored is no
longer defined in the
Domain configuration.
Define the DataStore in
the Domain
configuration.
3019 Duplicate routes for
DataStore %1, VT
Controller = %2
Error in the Domain
configuration.
Contact the Product
Support.
3020 DataStore Id %1 is
unknown
Error in the Domain
configuration.
Contact the Product
Support.
3021 MountId: %s. No active
VTC is a route between
the NSK node and the
DataStore %s for
mounting %s.
The Domain
configuration does not
contain an active VT
Controller route to
access the named
DataStore.
Configure or activate a
VTC that:
- has a/the tape device
connected to the NSK
node where to mount
the volume
- is a route to the
DataStore where the
volume was created.
3022 MountId: %s. MountId
for volume %s is no
longer pending
The tape mount id
associated with a load
request is not in the list
of pending mounts in
MEDIACOM.
Check if the application
is still running.
3023 MountId: %1.%2.
%3(label) loaded on
%4(device). %5
A mount request was
successfully executed.
None.
3024 Invalid user name or
password
A Guardian logon
procedure failed.
Check Guardian user
name and password.
3025 Add volume %1 label
Type %2 in pool %3
catalog %4 rejected by
MEDIASRV code %5
An error occurred while
updating a DSM/TC
catalog.
Refer to the DSM/TC
Management
Programming HP
NonStop manual.