BackPak H4.00 Troubleshooting and Messages Manual

Messages
55 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3150 BBCMD stops retrying
sending a '%s' message
to the Domain Manager
after %ld retries.
The retry limits specified
in EZXSETUP/BBSETUP
file are reached. BBCMD
and the current TACL
macro end with error.
Check the cause of
errors in previous
messages and in EMS
log.
3151 VOLUME or STOREID
must be specified to free
an MVS dataset.
The macro
EZX_FREE_MVS_DATAS
ET must specify one of
these two parameters
Complete the call to
EZX_FREE_MVS_DATA
SET
3152 Automatic unload of
volume %s, after an
unrequested load on
%s.%s
An unrequested BackPak
tape volume was
loaded, the EMS
message #640
'UNREQUESTED ANSI
TAPE' is logged.
This condition is not
acceptable for regular
EZX transfers and the
volume is automatically
unloaded.
Verify the automatic
unload is appropriate
for the case.
This condition occurs
when the tape
application program
stops or abends just
during the processing
of the load, or the tape
volume recognition.
3153 No automatic unload of
volume %s, after an
unrequested load on
%s.%s. %s
The EMS message #640
'UNREQUESTED ANSI
TAPE' is logged, but the
state of the unrequested
volume is not
consistent.
Verify the conditions of
current transfer.
To manually get rid of
an unrequested load,
use the Inload
command on the Home
page of the Web user
interface. This will
unload the volume,
reset the current
operation of the
volume, and deallocate
the MVS datasets.
3154 MountId: %s. Volume
%s. MVS DSN %s in the
TAPE DEFINE does not
the match and overrides
the DSN %s recorded by
EZX_SETUP_XFER
macro for volume %s.
Mismatch between the
data received by the
Domain Manager when
the EZX_START_ZFER
macro executed, and
when the mount request
was issued by $ZSVR.
This is a warning.
Check the execution of
the EZX_START_XFER
macro that should be
run to build the TAPE
DEFINE.