BackPak H4.00 Troubleshooting and Messages Manual

Messages
56 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3155 EZX_START_XFER
R_RECFM=%s
R_LRECL=%ld
R_BLKSIZE=%ld:
{DCB-error-text}.
Volume %s (%s.%s %s)
The consistency check
failed on the DCB
parameters (RECFM,
LRECL,BLKSIZE) of the
MVS dataset. Error is
specified by the DCB-
error-text.
Check the DCB
parameters of the
EZX_START_XFER
macro.
3156 MountId: %s. Device
'%s' requested to load
%s is not free, or not on
an active VTC that is a
route to the DataStore
%s.
The device requested to
load a volume is not
emulated by a VTC that
is active and that is a
route to the DataStore.
Or the drive is not free.
Check the Domain
configuration:
- the VTC is a route to
the DataStore
associated to the tape
volume
- the VTC is active.
Check the status of the
drive in the Status
node page.
3157 VTC %s rejects the
unloading of volume on
device %s.%s with error
%ld %s.
An unload command is
rejected by the VTC.
Check the error
condition reported in
the message.
3158 Completion of operation
(%s) of volume %s can
not be communicated to
the MVS Agent that has
allocated the dataset(s).
Current operation
changed to POST_TRF.
A communication error
prevents to send the
transfer completion data
to MVS.
The MVS dataset is still
locked and the MVS
audit file is not updated.
When the
communications with
MVS are re-
established, use the
Web user interface to
"reset the current
operation" of the tape
volume.
This will unlock the
MVS dataset and
register the actual
completion (may be a
failure or a success) of
the transfer in the MVS
audit file.