BackPak H4.00 Troubleshooting and Messages Manual

Messages
80 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3298 Volume %s is cataloged
in volcat %s pool %s
with media type %s, but
is configured by volume
group %s as type %s.
Media type
inconsistency might
prevent loaded volumes
from being accepted by
$ZSVR.
NonStop tape system
requires the media type
cataloged for volumes in
DSMTC must match the
tape drive type.
When labeling new
volumes, BackPak will
catalog the volumes
according the media
type configured in the
BackPak volume group,
that should match the
type of tape drives of
the library.
To ensure the
appropriate media type
is assigned to volumes
labeled by BackPak,
verify the configuration
of BackPak volume
group.
3299 There is no unknown
volume to label in
library %s.
A labeling process is
iniated on a library that
does not contain any
appropriate volume, i.e.
volume that is both
unknown in the BackPak
catalog and has a valid
bar-coded label.
Before beginning the
labeling operation:
- insert new media
in the library
- delete in the
BackPak library,
the volumes to re-
label
3300 %s process %s.%s
initiated to process %ld
volumes in library %s.
A ‘LABELING’ or ‘MOVE
TO IE’, or ‘MOVE FROM
IE’ process is initiated in
the background.
None.
3301 Cannot initiate a %s
process until the end of
the %s process %s.%s
already running for the
same data store %s.
A ‘LABELING’ or ‘MOVE
TO IE’, or ‘MOVE FROM
IE’ process cannot be
initiated.
A single such process
can run at a time for per
library.
Wait the end of
process to initiated
another one.
3302 Maximum number of
labelling drives %ld is
invalid.
A library volumes
labeling process is
initiated with an invalid
number of drives.
Re-issue the command
with a number of
drives, numeric, non-
zero, and not greater
than the number of
drives configured for
the library.