BackPak H4.00 Troubleshooting and Messages Manual

Messages
93 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3371 Erreur loading
BackboxDeviceStatus
reply from %s: port %d
for device LUN %d
target %d not known by
VTC.
A VTC rejects a request
because it refers a
port/device that is not
defined by the internal
VTC configuration
(
FCConfig.txt or
VTConfig.txt
).
In the GUI, VTC
configuration page,
verify the domain
configuration matches
the internal VTC
configuration.
Verify SCF device
configuration matches
also (check WWN).
Possibly fix
FCConfig.txt or
VTConfig.txt in the
VTC.
3372 No drive is configured. A status query in the
BackPak GUI has no
data to return, as there
is no tape drive
configured.
Have minimally a
virtual tape drive
configured in a non-
disabled VTC before
querying the status.
3373 MountId: %s. Volume
%s still not loaded after
%d minutes, exceeds
the configured warning
threshold of %d
minutes. Request time
was %s.
The configured
maximum delay for
loading a tape volume
has been reached.
Analyze EMS messages
since the mount
request, in the node
where the volume is
requested. If the
domain manager is
running in another
node, check EMS in
this other node too.
Possibly adjust the
maximum mount delay
in the domain
configuration, Domain
page.
3374 %ld drives not
supporting %s media
type.
While searching a tape
drive for replying to a
load request, some
drives were not eligible
because not supporting
the requested media
type.
This is a sub-message
included in message
#3227.
Verify the media type
in the domain
configuration, Volume
group page.
If DSM/TC, verify the
media type of the
TAPEVOLUME.