BackPak H4.00 Troubleshooting and Messages Manual

Messages
98 BackPak H4.00 Troubleshooting & Messages
Number Text Explanation Action
3400 No encryption on
Volume group %s Data
store %s for NonStop
%s using the Key
manager %s.
There is no possible load
of encrypted volumes
for the specified Volume
group.
See other error
messages reported by
the Key manager test
page.
3401 MountId: %s.
Decrypting volume %s
using Key manager ‘%s’
is impossible: Key
manager %s not
configured.
A mount request is
rejected because the
Key manager required
to read and decrypt the
volume is not configured
in the BackPak domain.
Configure the Key
manager ID associated
to this volume.
See also “Recovery of
encryption related
errors”.
3402 MountId: %s.
Encrypting volume %s
in group %s using Key
manager ‘%’s is
impossible: Key
manager not configured.
A mount request is
rejected because the
Key manager required
to encrypt and write the
volume is not configured
in the BackPak domain.
Configure the Key
manager ID associated
to this Volume group.
See also “Recovery of
encryption related
errors”.
3403 MountId: %s.
Impossible to decrypt
volume %s using the
key manager %s %s
when the Volume group
%s is configured for
writing using the
different Key manager
%s %s.
A mount request is
rejected because when
HP VLE is involved, the
same Key manager
must be used for both
the decryption (Key
manager associated to
the volume) and the
encryption (Key
manager associated to
the Volume group).
Fix the BackPak
configuration.
See also “Recovery of
encryption related
errors”.
3404 Timeout, more than %ld
seconds executing %s
command '%s' on node
%s
A query has been
submitted by starting a
NonStop system utility
that does not end in
expected time.
If this symptom is
explained by a
temporary system
global state, retry the
command.
Refer to Error
triggering a NonStop
utility