BackPak H4.00 User Interface Client Installation

Install BackPak UI Client
16 BackPak H4.00 UI Client Installation
2. In the upper menu, click “Domain Address Configuration” to display the tab where
the domain address is to be registered.
Figure 7 – UI Client - Empty Domain address page
3. Click on the Add Domain
Figure 8 – UI Client - Sample Domain address page
Domain name: Enter the domain identifier. This identifier must be identical to the
domain name that will be entered in the BackPak domain
configuration.
Discrepancies on domain Id are tolerated during the configuration but
must be solved before actual operation on virtual volumes.
Guardian IP port: Enter the port that was configured in PORTCONF when PackPak was
installed on NonStop.