BladeCluster Solution Manual

Software Requirements for the Current Release of BladeCluster
NOTE: If your topology includes nodes that only connect to 6700 series fabrics and not to
BladeCluster fabrics, these software requirements do not apply. Instead, follow the “Software
Requirements for BladeCluster/6700 Series Solution” (page 57) for these nodes.
All of the required software shown in this table is for the current version of BladeCluster and it is
included in the J06.12 and H06.23 RVUs. This software can be installed on H06.14/J06.04 and
later RVUs without requiring a system load. For previous BladeCluster releases, see “Software
Requirements for Previous Releases of BladeCluster” (page 23).
Table 2 Software Requirements for BladeClusters (H06.23 and J06.12 RVUs)
Software Process Revision (SPR)Software Component
T0509H01 AAGExpand/ServerNet profile
T0502H01 ABBSANMAN
1
T0294H01 ABFSNETMON/MSGMON
2
T4805A01 AARME Firmware
NonStop BladeSystems (J-series RVUs only)
T0815H01 AAAServerNet Switch FPGA Firmware
NonStop BladeSystems (J-series RVUs only)
T2805A01 AASME Firmware
NonStop NS16000 Series Systems (H-series RVUs only)
T5808H01 ABKSP to NSK Event Translator
T6522H01 AARNSK Service Processor I/O Library (SPIOLIB)
T0633G07 ABMOSM Low-Level Link
T0682H02 ACNOSM Service Connection Suite
3
T0988H01BladeCluster Solution Base License File
4
T0999H01BladeCluster Solution Interzone License File
5
T0930H01BladeCluster Solution Extended Long-Haul License
6
IMPORTANT: H06.23 and J06.12 and later RVUs are
required for all nodes connected to a multi-zone topology
with inter-zone distances greater than 25 km.
1
CAUTION: You should neither configure nor start the $ZZSMN (SANMAN) process unless the BladeCluster will be
connected to a 6700 series ServerNet cluster. The SANMAN process supports 6770 or 6780 ServerNet cluster switches
and is not needed unless these switches are present.
2
A newer SNETMON/MSGMON SPR provides support for multi-zone BladeCluster/6700 configurations in which the
zones are connected only along the 6700 cluster fabrics. For details, refer to “Important Considerations for Multi-Zone
Topologies” (page 17).
3
A newer OSM SPR provides an alarm suppression feature and is supported on this BladeCluster release. For more
information, refer to “Using OSM to Suppress BladeCluster Alarms” (page 83).
4
The BladeCluster Solution Base License (T0988H01) is not required for 6700 series ServerNet clusters that only connect
to 6700 series fabrics.
5
T0999H01 is required only in anchor nodes of multi-zone BladeCluster topologies with inter-zone distances up to 25
km.
6
T0930H01 is required only in anchor nodes of multi-zone BladeCluster topologies with inter-zone distances greater than
25 km.
22 BladeCluster Solution Overview